Forum

I have the enhancer that is for sale here on the home page, I have it installed on a 2000 pontiac bonneville,

( hooked to the maf sensor) factory setting out to ecm is 2.9 volts, with enhancer on

it is 5.1 volts on 0 setting, it does not change until I turn the knob to about 7.5 and

then it changes to 4 volts and at 10 it goes to 2.9, same as the factory setting, does

this seem correct? also I have the inlet from the generator in the air intake just in front

throttle body, is this a good spot? thanks

tested the enhancer on the battery and it works fine, but hooked to the maf it acts

funny, I have it hooked to the varible voltage wire, it is 2.9 volts at idle from the sensor

without the enhancer on , with it on it drops the voltage to the sensor to .8 , and 

output to the ecm changes to 5.1  on 0 setting and on setting 10 it goes to 2.9,  

would I be better off hooking into the map sensor?

is the signalwire the one that changes voltage or the constant one?