Videos of the Eco-Generator I
Read More ......

This page is design to help everyone to install their enhancers. Here is the specifics of the wiring of each individual vehicle that has become available to us.
Read More ......

Basic operation of an Oxygen (O2) Sensor: The O2 Sensor is basically a device that measures the oxygen content in the combustion results (exhaust gases) of an engine. The more oxygen in the exhaust gases, the leaner the mixture and the less oxygen, the richer the mixture. The working voltage is from 0v (0mv) to 1v (1000mv); the leaner the exhaust gases (more oxygen) the lower the voltage and the richer the exhaust gases (less oxygen) the higher the voltage leaving 500mv as the perfect mixture. If a volt meter is connected at the signal wire, the changing in voltage can be seen. The Electronic Control Module (ECM) tries to keep the voltage around 400mv to 600mv (lean to rich, rich to lean) and this is going on all the time while the engine is running. If the voltage signal from the O2 sensor is below 500mv (lean, too much oxygen), the ECM compensates by sending more fuel (gasoline) to the mixture and if is above 500mv (rich, not enough oxygen), it compensates by sending less fuel to the mixture.
Read More ......

In process
Read More ......

1. EFIE
   Read More ......

For custom installation quotes, complete the form below.
Read More ......

This client wanted a more professional installation in his new truck; he did not want the enhancer box looking out of place on the dash.
Read More ......

World’s fuel prices by the gallon.
Read More ......

Here you can find the wiring diagram for our units.
Read More ......

Here you can find the wiring diagram for our units.
Read More ......