Enhancers

Basic operation of an Oxygen (O2) Sensor: The O2 Sensor is basically a device that measures the oxygen content in the combustion results (exhaust gases) of an engine. The more oxygen in the exhaust gases, the leaner the mixture and the less oxygen, the richer the mixture. The working voltage is from 0v (0mv) to 1v (1000mv); the leaner the exhaust gases (more oxygen) the lower the voltage and the richer the exhaust gases (less oxygen) the higher the voltage leaving 500mv as the perfect mixture. If a volt meter is connected at the signal wire, the changing in voltage can be seen. The Electronic Control Module (ECM) tries to keep the voltage around 400mv to 600mv (lean to rich, rich to lean) and this is going on all the time while the engine is running. If the voltage signal from the O2 sensor is below 500mv (lean, too much oxygen), the ECM compensates by sending more fuel (gasoline) to the mixture and if is above 500mv (rich, not enough oxygen), it compensates by sending less fuel to the mixture.
Read More ......

This client wanted a more professional installation in his new truck; he did not want the enhancer box looking out of place on the dash.
Read More ......

Read More ......

To test the MAP/MAF enhancer, you will need a power source. The battery of your vehicle will do just fine as your power supply.
Read More ......

This is a must have if you are using an HHO Generator setup. This is the ultimate HHO add on, allowing you to have full control over your fuel intake. The gas mileage benefits are not seen without this device. With this unit you will have complete control over you map sensor with a flip of the switch. You can take your car from factory standards to the enhanced setup. Built using Water4Gas technical specs, the unit has one potentiometer of 270 degree rotation for precise adjustment .
Read More ......

Have you ever wondered the amperage that your HHO generator is running at?

Wonder no more with this unit, you will be able to see the HHO generator amperage at all time combine with the Water4Gas specs MAP/MAF sensor enhancer. With the flip of a switch, you take your car from factory to the enhanced setup, when the switch is in the factory mode the HHO generator and the enhancer are off and they are both on in the enhanced mode.
Read More ......

This is the Ultimate HHO add on, allowing you to have full control over your fuel intake. The gas mileage benefits are not seen without this device. With this unit you will have complete control over you map sensor with a flip of the switch you can take your car from factory standards to the economy setup.
Read More ......

These is a must have if you are using an HHO Generator Setup. This is the Ultimate HHO add on, allowing you to have full control over your fuel intake.
Read More ......